Search found 7 matches
- Mon Nov 13, 2023 7:16 pm
- Forum: DA20 Forum
- Topic: DA20 Autopilot Available
- Replies: 2
- Views: 1603
Re: DA20 Autopilot Available
Hi, Do you have an idea of how much you want for the parts? I have one of the 29 planes with the STec30 installed (N146DR). My AP has never worked properly as it tends to wander, but I haven’t really worried about it. I suspect it’s the controller which is part of gauge in the dash? You can PM me yo...
- Tue Aug 27, 2019 4:20 pm
- Forum: DA20 Forum
- Topic: Plane pulls to the right
- Replies: 4
- Views: 4056
Re: Plane pulls to the right
You should also check the alignment of your flaps. I had a similar problem but turning to the left. My AMO turned the actuator bolt out half a turn on the left side IIRC and that cured the problem.
- Sat Jun 22, 2019 8:21 pm
- Forum: DA20 Forum
- Topic: Landing gear vibration
- Replies: 6
- Views: 4800
Re: Landing gear vibration
There you go Maintenance Practices 6. Adjust the Nose Landing Steering Friction Steering friction prevents nose wheel shimmy. A. Equipment Refer to Chapter 07-10-00 for the equipment required for jacking the aircraft. B. Procedure DA20-C1 AMM Detail Steps/Work Items Key Items/References 1. Jack the ...
- Sat Jun 22, 2019 8:15 pm
- Forum: DA20 Forum
- Topic: Landing gear vibration
- Replies: 6
- Views: 4800
Re: Landing gear vibration
Have you tried tightening the bolt that holds the castoring arm onto the gear leg? If it’s too loose the wheel will shimmy.
The maintenance manual gives a description of how much the bolt must be tightened.
The nose wheel should not turn on this bolt too easily when you drop the tail.
The maintenance manual gives a description of how much the bolt must be tightened.
The nose wheel should not turn on this bolt too easily when you drop the tail.
- Thu Dec 06, 2018 3:14 pm
- Forum: DA20 Forum
- Topic: NLG Replacement Rubber
- Replies: 24
- Views: 11931
Re: NLG Replacement Rubber
Per replacing the pucks, I can't remember the cost of the pucks from Diamond, not cheap I am sure. A manufacture source would be nice. See post #2 in this thread... Steve Spot on Steve, I also got my pucks from Berger Tools, well worth the effort. They even machined the pucks down to the correct th...
- Mon Mar 19, 2018 8:19 pm
- Forum: DA20 Forum
- Topic: Dynon SkyView HDX now certified for C172
- Replies: 4
- Views: 2165
Re: Dynon SkyView HDX now certified for C172
If Dynon ever gets around to certify this for steam gauge DA20-C1s, I think I will pull the trigger. Apparently this will cost 20k$ plus installation. Well worth it in my humble opinion. https://www.dynonavionics.com/certified/index.php Just had a look at the Dynon site the price for the STC is $2K...
- Sun Sep 10, 2017 12:57 pm
- Forum: DA20 Forum
- Topic: Flap control module lamps
- Replies: 16
- Views: 13119
Re: Flap control module lamps
I thought I had the same problem, pulled the unit but avionics company couldn't find the fault. Put it back & the unit eventually started working again? I subsequently discovered that if the cabin lighting is switched on the led's dim to the extent that they can't be seen in daylight & that ...