Hi ,
I would like to replace many of the faded aircraft and cockpit decals in my Da20-C1.
Does anyone have a source for them other than the genuine Diamond ones ,I was shocked at the original costs....
Thanks
Regards Andrew.
Aircraft Decals Da 20.
Moderators: Rick, Lance Murray
- Fishovertime
- 2 Diamonds Member
- Posts: 13
- Joined: Mon Nov 17, 2014 1:56 am
- First Name: Andrew
- Aircraft Type: OTHER
- Aircraft Registration: 8P-DIM
- Airports: BGI
- shorton
- 2 Diamonds Member
- Posts: 44
- Joined: Thu Jan 17, 2013 7:42 pm
- First Name: Scott
- Aircraft Type: DA42NG
- Aircraft Registration: N68MJ
- Airports: KSNA
- Has thanked: 11 times
- Been thanked: 21 times
Re: Aircraft Decals Da 20.
Aerographics.com. They have a good selection of the factory designs at a lower cost. I got new decals from them for my DA40.
They also had very good customer service on the phone if you have any questions.
They also had very good customer service on the phone if you have any questions.
- Fishovertime
- 2 Diamonds Member
- Posts: 13
- Joined: Mon Nov 17, 2014 1:56 am
- First Name: Andrew
- Aircraft Type: OTHER
- Aircraft Registration: 8P-DIM
- Airports: BGI
Re: Aircraft Decals Da 20.
Scott,
Did you get you just get exterior stripes ? or placards etc..
Andrew.
Did you get you just get exterior stripes ? or placards etc..
Andrew.
- shorton
- 2 Diamonds Member
- Posts: 44
- Joined: Thu Jan 17, 2013 7:42 pm
- First Name: Scott
- Aircraft Type: DA42NG
- Aircraft Registration: N68MJ
- Airports: KSNA
- Has thanked: 11 times
- Been thanked: 21 times
Re: Aircraft Decals Da 20.
Just exterior stripes and registration number. From memory, I think the total was just over $700. Probably paid that much in labor to remove the old baked on stripes and place the new.
- Chris B
- 5 Diamonds Member
- Posts: 843
- Joined: Wed Sep 26, 2012 1:52 am
- First Name: Chris
- Aircraft Type: DA40
- Aircraft Registration: N171CB
- Airports: KRHV
- Has thanked: 210 times
- Been thanked: 215 times
Re: Aircraft Decals Da 20.
Hi Andrew -
For placards, check with Brittany at Premier. She was able to set me up with left overs from a large sheet at much more reasonable cost (~$20 ea?). This is at least worth a shot. Just look up the specific Diamond PNs in the parts catalog & give her a call.
Chris
For placards, check with Brittany at Premier. She was able to set me up with left overs from a large sheet at much more reasonable cost (~$20 ea?). This is at least worth a shot. Just look up the specific Diamond PNs in the parts catalog & give her a call.
Chris