Page 1 of 1

Dynon SkyView HDX now certified for C172

Posted: Thu Mar 15, 2018 1:34 am
by Pascal
If Dynon ever gets around to certify this for steam gauge DA20-C1s, I think I will pull the trigger. Apparently this will cost 20k$ plus installation. Well worth it in my humble opinion.

https://www.dynonavionics.com/certified/index.php

Re: Dynon SkyView HDX now certified for C172

Posted: Thu Mar 15, 2018 2:22 am
by gordsh
It actually looks really nice. Reminds me of the Garmin 3CX Touch Display which is for Experimental only. The 3CX to me (in my limited experience) beats the G1000 in my DA40 based on what I have seen so far.

Re: Dynon SkyView HDX now certified for C172

Posted: Thu Mar 15, 2018 11:58 pm
by gordsh

Re: Dynon SkyView HDX now certified for C172

Posted: Mon Mar 19, 2018 8:19 pm
by CWS
Pascal wrote:If Dynon ever gets around to certify this for steam gauge DA20-C1s, I think I will pull the trigger. Apparently this will cost 20k$ plus installation. Well worth it in my humble opinion.

https://www.dynonavionics.com/certified/index.php
Just had a look at the Dynon site the price for the STC is $2K, the 10 inch unit +-$4,5K & the 7inch unit +-$3,2K (same price as the non certified units) so unless I am missing something the price without install will be just shy of $7K for the single 10 inch unit. As Pascal says hope Dynon add the DA20 to the STC would be a great upgrade.

Re: Dynon SkyView HDX now certified for C172

Posted: Tue Mar 20, 2018 2:13 am
by thefoxx
We should all send a message into Dynon about our willingness to purchase for our DA20's (or other Diamonds for that matter that could use this upgrade!) I'm real excited about it!