Maybe I missed it in the DA42 POH, but I'm looking for help with simulation of "zero thrust" for practicing one engine inoperative (OEI) procedures.
Rather than setting one of the Engine Master switches to OFF to actually shut down and feather a DA42 engine (which must be restarted within 2 minutes below 10,000 feet), it's possible to simulate an engine failure and feathering by pulling the throttle back to a small percentage of power. The small amount of engine power should exactly offset the drag produced by a windmilling propeller, resulting in zero thrust from that engine.
My question specifically is what percentage engine power to use for this? I've been given conflicting advice by different instructors: some say 11% power, some say 20% power. This makes a HUGE difference in the amount of rudder required to counter the asymmetrical thrust, especially when the other engine is producing 100% power (such as during simulated critical engine failure after takeoff when a positive rate of climb is required).
I'm guessing the answer might be different for Thielert vs. Austro engines, but I'd like to hear what % power people have been using for the simulated feathered engine.
- Dave
Simulating zero thrust
Moderators: Rick, Lance Murray
- CFIDave
- 5 Diamonds Member
- Posts: 2682
- Joined: Wed Nov 07, 2012 3:40 pm
- First Name: Dave
- Aircraft Type: OTHER
- Aircraft Registration: N333GX
- Airports: KJYO Leesburg VA
- Has thanked: 234 times
- Been thanked: 1480 times
Simulating zero thrust
Epic Aircraft E1000 GX
Former DA40XLS, DA42-VI, and DA62 owner
ATP, CFI, CFI-I, MEI
Former DA40XLS, DA42-VI, and DA62 owner
ATP, CFI, CFI-I, MEI
- carym
- 5 Diamonds Member
- Posts: 1021
- Joined: Sat Aug 28, 2010 5:00 pm
- First Name: cary
- Aircraft Type: DA42
- Aircraft Registration: N336TS
- Airports: KTYQ
- Has thanked: 37 times
- Been thanked: 83 times
Re: Simulating zero thrust
I had been confused by this as well. I had used around 15% but that was an arbitrary value. Last summer we actually measured how much I needed. We shut down the right engine and put the left at 100%. We noted what airspeed was needed to maintain altitude. We then restarted the right engine and determined how much power was needed to match the same parameters as when shut down. Turns out on that day, at that temperature and altitude, we needed 20% power on the right engine. I have been using that value ever since. It may not be exact, and it may depend upon which engine is not operative, but I think it is close enough to keep me in OEI proficiency. I have the 1.7 engines.
Cary
DA42.AC036 (returned)
S35 (1964 V-tail Bonanza)
Alaska adventure: http://mariashflying.tumblr.com
DA42.AC036 (returned)
S35 (1964 V-tail Bonanza)
Alaska adventure: http://mariashflying.tumblr.com
- Jeff
- 3 Diamonds Member
- Posts: 122
- Joined: Wed Jul 07, 2010 11:33 am
- First Name: Jeff
- Aircraft Type: DA62
- Aircraft Registration: MANY
- Airports: KFXE
- Been thanked: 32 times
Re: Simulating zero thrust
I always use 11% but will get a "factory recommended" answer to lay this question to rest officially.
Jeff Owen
Diamond Aircraft Specialist
Premier Aircraft Sales, Inc.
Fort Lauderdale, FL
954-771-0411
jeff.owen@flypas.com
http://www.flypas.com
Diamond Aircraft Specialist
Premier Aircraft Sales, Inc.
Fort Lauderdale, FL
954-771-0411
jeff.owen@flypas.com
http://www.flypas.com
- Aart
- 4 Diamonds Member
- Posts: 447
- Joined: Fri Jun 18, 2010 4:27 pm
- First Name: Aart
- Aircraft Type: DA42
- Airports:
- Has thanked: 21 times
- Been thanked: 22 times
Re: Simulating zero thrust
10% was what was taught to me too. Look forward to Jeff's 'factory recommended' answer.
Aart
DA42.332 PH-CCD LESB (Palma de Mallorca, Spain)
DA42.332 PH-CCD LESB (Palma de Mallorca, Spain)
- Jeff
- 3 Diamonds Member
- Posts: 122
- Joined: Wed Jul 07, 2010 11:33 am
- First Name: Jeff
- Aircraft Type: DA62
- Aircraft Registration: MANY
- Airports: KFXE
- Been thanked: 32 times
Re: Simulating zero thrust
Here is your answer right from Peter Schmidleitner at Diamond Austria
For the DA42 TDI we said: "10 to 11% Load".
For the NG:
Although the test pilots said for "zero thrust" the power lever could be placed to idle, I do not believe this.
We recommend "about 8% Load".
Kind regards,
Peter
For the DA42 TDI we said: "10 to 11% Load".
For the NG:
Although the test pilots said for "zero thrust" the power lever could be placed to idle, I do not believe this.
We recommend "about 8% Load".
Kind regards,
Peter
Jeff wrote:I always use 11% but will get a "factory recommended" answer to lay this question to rest officially.
Jeff Owen
Diamond Aircraft Specialist
Premier Aircraft Sales, Inc.
Fort Lauderdale, FL
954-771-0411
jeff.owen@flypas.com
http://www.flypas.com
Diamond Aircraft Specialist
Premier Aircraft Sales, Inc.
Fort Lauderdale, FL
954-771-0411
jeff.owen@flypas.com
http://www.flypas.com
- CFIDave
- 5 Diamonds Member
- Posts: 2682
- Joined: Wed Nov 07, 2012 3:40 pm
- First Name: Dave
- Aircraft Type: OTHER
- Aircraft Registration: N333GX
- Airports: KJYO Leesburg VA
- Has thanked: 234 times
- Been thanked: 1480 times
Re: Simulating zero thrust
Only 8% power on the NG?!!!
Wow, I guess all Austrians must be built like Arnold Schwarzenegger with incredibly strong leg muscles!
Wow, I guess all Austrians must be built like Arnold Schwarzenegger with incredibly strong leg muscles!
Epic Aircraft E1000 GX
Former DA40XLS, DA42-VI, and DA62 owner
ATP, CFI, CFI-I, MEI
Former DA40XLS, DA42-VI, and DA62 owner
ATP, CFI, CFI-I, MEI
- Jeff
- 3 Diamonds Member
- Posts: 122
- Joined: Wed Jul 07, 2010 11:33 am
- First Name: Jeff
- Aircraft Type: DA62
- Aircraft Registration: MANY
- Airports: KFXE
- Been thanked: 32 times
Re: Simulating zero thrust
I for one am glad that 4 good turns of the rudder trim knob usually solve the problem
CFIDave wrote:Only 8% power on the NG?!!!
Wow, I guess all Austrians must be built like Arnold Schwarzenegger with incredibly strong leg muscles!
Jeff Owen
Diamond Aircraft Specialist
Premier Aircraft Sales, Inc.
Fort Lauderdale, FL
954-771-0411
jeff.owen@flypas.com
http://www.flypas.com
Diamond Aircraft Specialist
Premier Aircraft Sales, Inc.
Fort Lauderdale, FL
954-771-0411
jeff.owen@flypas.com
http://www.flypas.com